Having problems fixturing a small section of a cone. Brittle material and can't use anything on the inside for support as that arc is not smooth. Trying to make a fixture that will repeat so we can use cad to measure the surface profile. We tried a magnet with a small lip but even with part against the stops we aren't sure what to use for alignment (thickness of part from OD to ID (after ID is finished) is 1.2mm which is what the 45° edges are (not much for manual hits:blah.
20230427134833855.pdf
Caemgen, I will look into the dental mold right now (& you have me wondering if I could use that 'temporary crown' stuff for when one falls out) - thank you (I've tried sugru but it seems to flex too much when taking hits on the top)
Caemgen, I will look into the dental mold right now (& you have me wondering if I could use that 'temporary crown' stuff for when one falls out) - thank you (I've tried sugru but it seems to flex too much when taking hits on the top)