Having problems fixturing a small section of a cone. Brittle material and can't use anything on the inside for support as that arc is not smooth. Trying to make a fixture that will repeat so we can use cad to measure the surface profile. We tried a magnet with a small lip but even with part against the stops we aren't sure what to use for alignment (thickness of part from OD to ID (after ID is finished) is 1.2mm which is what the 45° edges are (not much for manual hits:blah.
20230427134833855.pdf
Thank you Jefman, Do you use something other than the 'removeable adhesive rubber' ? only asking as I tried using the putty we clean our probe connection with & it flexed more than we felt comfortable with
Thank you Jefman, Do you use something other than the 'removeable adhesive rubber' ? only asking as I tried using the putty we clean our probe connection with & it flexed more than we felt comfortable with