Hello all,
Long time, no talk. I hope everyone is doing well.
I know there is a setting in the settings editor that needs to be changed in order for me to create an Iterative alignment using three edge points. I just can't for the life of me remember what the heck it is. We swapped out PC's some time ago and now the programs we created in the past will not align or run correctly.
I'm thinking it was edge point only mode or something. I know we used to change tesselation values and donotuseamyrtf settings in there. Just can't remember what that was that allowed you to construct that alignment using three points.
Thanks in advance for any assistance...
