hexagon logo
Register Sign in
  • Replies 27 replies
  • Subscribers 223 subscribers
  • Views 272 views
  • Users 0 members are here
Options
Related

Pass fail to tolerances

Peter Martignacco
Here is my problem. If I say I only want to report 3 digits and .005+/-.001 and the result is .0061 it will show me a fail. I want it to show me a pass. Same with .0039 want to show as a pass.

Anything in the software that I can turn on to correct the pass fail with that?

Any thoughts would helpful can think of some work arounds.
​
Parents
  • When you set your displayprecision to 3, the screen would show the tolerance of ±.001, but it could be set for ".00149" however be sure your nominal value is set properly, or you will still get the miscellaneous flags you are trying to avoid.

    Personally, I feel it's bad practice but, if your establishment has rules to handle trailing values then you should be within the written rules by setting your tolerances up this way.
Reply
  • When you set your displayprecision to 3, the screen would show the tolerance of ±.001, but it could be set for ".00149" however be sure your nominal value is set properly, or you will still get the miscellaneous flags you are trying to avoid.

    Personally, I feel it's bad practice but, if your establishment has rules to handle trailing values then you should be within the written rules by setting your tolerances up this way.
Children
© 2024 Hexagon AB and/or its subsidiaries. Privacy Policy | Cloud Services Agreement