Here is my problem. If I say I only want to report 3 digits and .005+/-.001 and the result is .0061 it will show me a fail. I want it to show me a pass. Same with .0039 want to show as a pass.
Anything in the software that I can turn on to correct the pass fail with that?
Any thoughts would helpful can think of some work arounds.
CMM = Characterization Magic Manipulation ?????
Even if I think it's a very bad idea to accept OOT parts without a real customer acceptance, you can easily change the tol to 0.00549/-0.00149 with 3 decimal places, it should be invisible on the report numbers, but a part with a 0.005 deviation won't appear with a total graphic deviation...
It's a kind of magic, it's not metrology !!!!!
CMM = Characterization Magic Manipulation ?????
Even if I think it's a very bad idea to accept OOT parts without a real customer acceptance, you can easily change the tol to 0.00549/-0.00149 with 3 decimal places, it should be invisible on the report numbers, but a part with a 0.005 deviation won't appear with a total graphic deviation...
It's a kind of magic, it's not metrology !!!!!