I am trying to do an alignment where it’s plane , circle , circle but my x and y dimensions are not calling out properly by following the alignment the customer requested. Unless I’m misunderstanding I also don’t think the x y and x should be at an angle and that that is also why my callouts for dimensioning aren’t correct .
Probably becasue the circles are not in a line that is // to an edge ? You need to make an offset line based on the hole s and the basic listed on the print ? Copy the code and paste the print ? Screen shots from a monitor and cell phone are highly illegal here and frowned on ? ( )
Probably becasue the circles are not in a line that is // to an edge ? You need to make an offset line based on the hole s and the basic listed on the print ? Copy the code and paste the print ? Screen shots from a monitor and cell phone are highly illegal here and frowned on ? ( )
)