hexagon logo
Register Sign in
  • Replies 3 replies
  • Subscribers 222 subscribers
  • Views 37 views
  • Users 0 members are here
Options
Related

Change Target for find circle

mattfurtaw
I am struggling finding where to de-activate this. I don't want operators to be able to move probe and click yes to change target values if the probe does not find the hole. I should be to do this but can't figure out where outside of the auto feature window itself. After this doesn't find I will use the on error to handle the rest.

Any help ?
Parents
  • IF Pcd can not find the hole and asks the operator to position the probe over the hole so that Pcd can try again to measure it, they MUST do that, or, skip the hole and give no measured values for it. If you want to allow them to position the probe over the hole so Pcd CAN measure the hole after it couldn't find it, BUT you don't want the targets updated, YOU MAY be able to turn that off using the F5 warning list, but I am not sure. YOU CAN however, if nothing else, change the TARGET values of the problem hole to a math formula, and I 'THINK' that will keep Pcd from updating them even if the operator tells it to do so.
Reply
  • IF Pcd can not find the hole and asks the operator to position the probe over the hole so that Pcd can try again to measure it, they MUST do that, or, skip the hole and give no measured values for it. If you want to allow them to position the probe over the hole so Pcd CAN measure the hole after it couldn't find it, BUT you don't want the targets updated, YOU MAY be able to turn that off using the F5 warning list, but I am not sure. YOU CAN however, if nothing else, change the TARGET values of the problem hole to a math formula, and I 'THINK' that will keep Pcd from updating them even if the operator tells it to do so.
Children
No Data
© 2024 Hexagon AB and/or its subsidiaries. Privacy Policy | Cloud Services Agreement