Just trying to figure this out - when I dimension a circular feature I'll get one size but when adding a GD&T dimension for that same exact feature I get a different size altogether (example below). What's the reason for this?
I believe the default is set same as the "SA" toggle when using a size dimension FCF, double check me by adding in a size dimension, tabbing over to ISO from ASME and click SA when tolerancing the size.
Should report the same size as the diameter shown in a TP or any callout that allows the reporting of a diametrical size.
I believe the default is set same as the "SA" toggle when using a size dimension FCF, double check me by adding in a size dimension, tabbing over to ISO from ASME and click SA when tolerancing the size.
Should report the same size as the diameter shown in a TP or any callout that allows the reporting of a diametrical size.
