there is no one correct answer for TTP (other than MEASURE at the same touch speed as you calibrate), and the scanning hardware will determine the speed for analog.
Some of this depends on the probe system you have, the controller on the CMM and the tolerances you need to hold.
Everything should "qualified" at ABSOLUTE speeds and all of your programming needs to be done at ABSOLUTE also
there is no one correct answer for TTP (other than MEASURE at the same touch speed as you calibrate), and the scanning hardware will determine the speed for analog.
Some of this depends on the probe system you have, the controller on the CMM and the tolerances you need to hold.
Everything should "qualified" at ABSOLUTE speeds and all of your programming needs to be done at ABSOLUTE also
