Hello folks,
I have a problem evaluating a runout. It gives me the error message "this tolerance requires a data to be measured in circular cross sections".
But my auto cylinder is circular...
An auto-cylinder measured with multiple levels should work - the geometric tolerance command will automatically look at each level and pull out the circular cross sections, providing all the hits making up each level are at the same depths (within a certain tolerance). How are you measuring the auto-cylinder, is it DCC mode or manual? If it's in manual mode then the depth of each hit may be varying.
An auto-cylinder measured with multiple levels should work - the geometric tolerance command will automatically look at each level and pull out the circular cross sections, providing all the hits making up each level are at the same depths (within a certain tolerance). How are you measuring the auto-cylinder, is it DCC mode or manual? If it's in manual mode then the depth of each hit may be varying.
