I am trying to find out how I can add a "failsafe" to a program to keep operators from selecting wrong inspection programs and crashing our cmm. I want to add in code that after a program is selected the probe will search for a specific point on the part. When the point is found, I want the code to look at the point and if it equals a specified dimension, the program will continue to run. If the point taken does not equal the specified dimension, then the program will end and inform the operator that the wrong program was selected. Any help would be greatly appreciated.
[
Insert a picture of the part into the program thru the comment command. That should help verify the right part is loaded but not necessarily at the right operation.
this is what I do, but there is NO insurance from LCD(lowest common denominator) so good luck with that. if your CMM is getting crashed consistently it sounds like a "training opportunity" to me.
[
Insert a picture of the part into the program thru the comment command. That should help verify the right part is loaded but not necessarily at the right operation.
this is what I do, but there is NO insurance from LCD(lowest common denominator) so good luck with that. if your CMM is getting crashed consistently it sounds like a "training opportunity" to me.
