I am trying to find out how I can add a "failsafe" to a program to keep operators from selecting wrong inspection programs and crashing our cmm. I want to add in code that after a program is selected the probe will search for a specific point on the part. When the point is found, I want the code to look at the point and if it equals a specified dimension, the program will continue to run. If the point taken does not equal the specified dimension, then the program will end and inform the operator that the wrong program was selected. Any help would be greatly appreciated.
Thank you all for your suggestions. I do have pictures, part numbers and names of the part being inspected set up using the Inspect user interface, but that still does not seem to be enough. I was hoping that I could resolve the operator error using IF statements, sort of the way Bfire 85 suggested. Again thank you all again for your suggestions and insights.
Thank you all for your suggestions. I do have pictures, part numbers and names of the part being inspected set up using the Inspect user interface, but that still does not seem to be enough. I was hoping that I could resolve the operator error using IF statements, sort of the way Bfire 85 suggested. Again thank you all again for your suggestions and insights.
