I have a part that I need to do a FAI on that has over 700 dimensions. I was planning on splitting it up into several smaller programs. I believe I can get most of the features in 1 setup, so I was going to use external alignments. What I need help on is, a lot of the dimensions needed have modifiers on the datums. How can I get the datum features from a previous program into a current program so I can take advantage of the bonus available on the datum features?
I don't know if this will be possible. I'm not sure how you would be able to get PC-DMIS to evaluate the Simultaneous Tolerance requirement for features from different programs. The datum shift needs to be the same across the board, and if you have these split into different programs, each program will shift a different amount based on the features within it.
I don't know if this will be possible. I'm not sure how you would be able to get PC-DMIS to evaluate the Simultaneous Tolerance requirement for features from different programs. The datum shift needs to be the same across the board, and if you have these split into different programs, each program will shift a different amount based on the features within it.
