Command argument out of limit

Hi,
I am getting an error message "Command argument out of limit" whenever i try to ctrl+e a single feature of a program after the program has ran through fully. It is happening with all current programs. I feel another employee has changed a setting, has anyone ever had this issue before?

Thanks

Parents

BIGWIG7 over 1 year ago

^ BaigZadeh can you run the program from the beginning, then stop it in the middle, and then continue the program again?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
BaigZadeh over 1 year ago in reply to BIGWIG7

No, Program will run fine from start to beginning, but if i stop the program in the middle and try to execute the program from the cursor or a single feature etc, it moves towards the feature then stops and gives the error message "Command argument out of limit". It does this for any feature in all programs, even a new program i made to test. Its as if it is not holding on to the data/alignments once the program stops.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

BaigZadeh over 1 year ago in reply to BIGWIG7

No, Program will run fine from start to beginning, but if i stop the program in the middle and try to execute the program from the cursor or a single feature etc, it moves towards the feature then stops and gives the error message "Command argument out of limit". It does this for any feature in all programs, even a new program i made to test. Its as if it is not holding on to the data/alignments once the program stops.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data