Good morning. I hope all is well with everyone. Just wondering, does pc dmis have an option to search for the fatest measurement routine? Thaks for your insight.
top menu
Operation -> Graphics Display window-> "optimize path"
that being said, use at your own risk. i suggest that if you are going to use it then you should only use it in small sections at a time while programming. from my experience, using it on a completed program will cause crashes and hours of headaches. your best bet is to review the program and minimize your probes and tip angle changes, prehit / retract, clear planes and move points. I have been able to save up to 40 mins form some of our longer running programs (1-2 hours) by doing such.
top menu
Operation -> Graphics Display window-> "optimize path"
that being said, use at your own risk. i suggest that if you are going to use it then you should only use it in small sections at a time while programming. from my experience, using it on a completed program will cause crashes and hours of headaches. your best bet is to review the program and minimize your probes and tip angle changes, prehit / retract, clear planes and move points. I have been able to save up to 40 mins form some of our longer running programs (1-2 hours) by doing such.
