Good morning. I hope all is well with everyone. Just wondering, does pc dmis have an option to search for the fatest measurement routine? Thaks for your insight.
using fastprobe mode helps the machine run a little bit quicker also just make sure your prehit retracts are adequate
I have gotten into trouble using fast probing with longer stylus systems. A phantom hit 10mm in the air will be obvious, but one 10 microns in the air will not be.
all of our are long 70mm to 150mm tips ranging from 0.5 to 8mm Ø. ive seen nothing like your getting.. maybe your trigger settings are too low? all 4 of our machines are less than 5 microns to each other which is good enough in my opinion. touch speed is set to 0.5mm sec i believe so maybe yours is set higher>?not sure have the other probe setting are off hand but i dont really know your setup and we dont typically get phantom hits.
all of our are long 70mm to 150mm tips ranging from 0.5 to 8mm Ø. ive seen nothing like your getting.. maybe your trigger settings are too low? all 4 of our machines are less than 5 microns to each other which is good enough in my opinion. touch speed is set to 0.5mm sec i believe so maybe yours is set higher>?not sure have the other probe setting are off hand but i dont really know your setup and we dont typically get phantom hits.
