Hi guys, im very new to Pcdmis and CMM so bare with me I really need some help with this one.
Got a pipe. cylinder 16mm.
5 holes, 8.2mm
Problem - struggling to find away to create a circle on a cylinder, as a circle on a cylinder wont be flat.. Anyway of doing this?
I need to find out the angle of each of these holes to table plane. Thus should be 0 degree +/-1.5. basically holes pointing straight up. I can do this, just need to get these darn circles perfected on the cylinder....
Correct me if I'm wrong... would it be easier to take a cylinder instead of a circle and check if the cylinder is perpendicular to the table?
This is possible of course if the pipe is thick enough.
Correct me if I'm wrong... would it be easier to take a cylinder instead of a circle and check if the cylinder is perpendicular to the table?
This is possible of course if the pipe is thick enough.