Hello, hope all is well with everyone. I'm kinda losing it over here. Programming a part and everything started off fine. The issue started when it would make a hole I programmed. It was stopping .300" before the feature and trying to probe there. My coordinates matched print, but it just couldn't get to the hole. So I tried a few things and now when I set my Yminus clearplane to .-25 to come out of the readpoint hole and probe the plane...the machine just keeps traveling back until its out of limit.
Any ideas as to what is going on??? I'm going mad. It's a simple part but things are goofy. any insight would be greatly appreciated.
