Thanks for reading. I recently measured a part manually with measured circles and aligned said part. However, EVERYTHING is coming back at nominal. TP is exactly 0, and my diameters are exact. Any ideas? Thanks for your time.
Thanks for your response Jacob. I greatly appreciate it.
So, on the intial run through while live programming, the CMM will not relay measurements? And please forgive my ignorance, but what is meant by going back and correcting the nominal relationship between features?
Thanks for your response Jacob. I greatly appreciate it.
So, on the intial run through while live programming, the CMM will not relay measurements? And please forgive my ignorance, but what is meant by going back and correcting the nominal relationship between features?
