Help with TR_FG028, In-Position error - XCEL

Hello, my CMM allows me to move the probe around with the jogbox with no issues....until I execute a program. Once I execute a program, I can move around for a bit to pick up a manual point, but then the machine freezes and shortly after than the jogbox turns off and I get a TR_FG028, In-Position error.

I fear this is a symptom due to the Z axis being drove into the granite. I turned the air and controller on one day without realizing the main power wasnt on and the quill drove into the granite.

Any ideas on what could be causing this?

​

Hello, my CMM allows me to move the probe around with the jogbox with no issues....until I execute a program. Once I execute a program, I can move around for a bit to pick up a manual point, but then the machine freezes and shortly after than the jogbox turns off and I get a TR_FG028, In-Position error.

I fear this is a symptom due to the Z axis being drove into the granite. I turned the air and controller on one day without realizing the main power wasnt on and the quill drove into the granite.

Any ideas on what could be causing this?

​