Hi, all. Recently upgraded to 2023.2 and noticed a new feature in Auto-Cylinder. The feature is not working properly and i was wondering if there is a way to disable it?
If you are working directly in the auto-feature dialog, as soon as you edit the ending offset, it over-rides the smart calculation. If you are using quick features, you can disable the smart calculation through the measurement strategy editor.
I am using Auto-features. As you say, I can manually modify the ending offset and hit OK to create the feature. The problem I am having is after generating path, simulating, or performing a collision detection, it resets back to the "smart calculation" value, and I have to edit it all over again for all my cylinders. I've noticed even if I hit F9 on a cylinder feature, and then hit cancel, it will reset to the "smart calculation" value too. I find it a bit frustrating and looking for a way to completely disable it.
I am using Auto-features. As you say, I can manually modify the ending offset and hit OK to create the feature. The problem I am having is after generating path, simulating, or performing a collision detection, it resets back to the "smart calculation" value, and I have to edit it all over again for all my cylinders. I've noticed even if I hit F9 on a cylinder feature, and then hit cancel, it will reset to the "smart calculation" value too. I find it a bit frustrating and looking for a way to completely disable it.
