Hi, all. Recently upgraded to 2023.2 and noticed a new feature in Auto-Cylinder. The feature is not working properly and i was wondering if there is a way to disable it?
Create a cylinder with the offset that you want. Replace the X and Y values with variables. Copy the cylinder as needed and insert new values in the X and Y variables.
I'm using 2024.1 technical preview version and smart calculation is still overriding my value. It's so annoing especialy with program where i have many threads as cylinders and i must have exact ending offset where thread finishes. it is doing on each cylinder even it hasn't any bottom surface which can have collision with. And when i have lower cylinder than half of tip, ending offset is set out of material and program stops. it is very "usefull" when you have to go somewhere during execution and you expect that measurement is finished when you come back.
