hexagon logo
Register Sign in
  • Replies 12 replies
  • Subscribers 222 subscribers
  • Views 156 views
  • Users 0 members are here
Options
Related

I need help with measuring TP

Malgorzata
Good morning All,
I have a problem with TP. The position of the cylinders on the cone is at an angle. I need to understand why TP is out of tolerance if the diameter and position of these cylinders are correct.
Every tip is valuable.

-A- -> TOP PLN ( Z+ )
-B- ->ID CYL in center ( Z+ )
-C- -> cylinder on the side ( Y-)​
Attached Files
Parents
  • When I measure holes on an angle I create a circle from the intersect of the cylinder with the face it's on, this is what the print implies. From your report your PA is good but your PR is out, if it's still out after creating intersect circles then the bolt circle pattern needs to be adjusted smaller. Also, create a bolt circle from the 36 holes & verify it's at 31.50.
Reply
  • When I measure holes on an angle I create a circle from the intersect of the cylinder with the face it's on, this is what the print implies. From your report your PA is good but your PR is out, if it's still out after creating intersect circles then the bolt circle pattern needs to be adjusted smaller. Also, create a bolt circle from the 36 holes & verify it's at 31.50.
Children
No Data
© 2024 Hexagon AB and/or its subsidiaries. Privacy Policy | Cloud Services Agreement