hexagon logo
Register Sign in
  • Replies 8 replies
  • Subscribers 222 subscribers
  • Views 98 views
  • Users 0 members are here
Options
Related

Old style start for program?

RobOntario
Hello all friends around world.

I am evaluating programs from our supplier now. One program with Plane Circle round slot datums starts with iterate alignment. I wonder whether this is old style start since It takes at least 5 mins on manual hits before running DCC.

Attached Files
Parents
  • If using iterative alignment...

    Manual iterative should be MEASURE ALL ONCE with a large target pnt radius & like 2-3 iterations

    Should immediately be followed by a DCC alignment (MEASURE ALL ALWAYS) with a tighter target point radius

    Above said..this program is very poor quality & agreeing with above I'd suspect there are a lot of issues in it.
  • in reply to DAN_M
    if it is set to measure all once, then even if you no longer NEED to measure the manual for more parts because of your setup, it will force you to measure them again anyway, won't it? Even if you unmark them, when you run, it will mark them for you, won't it? Measure all = never and it will only measure them IF you mark them, so if you have a 'good enough' setup, you can unmark-all, the mark-all no manual and you won't have to probe the part again.
Reply
  • in reply to DAN_M
    if it is set to measure all once, then even if you no longer NEED to measure the manual for more parts because of your setup, it will force you to measure them again anyway, won't it? Even if you unmark them, when you run, it will mark them for you, won't it? Measure all = never and it will only measure them IF you mark them, so if you have a 'good enough' setup, you can unmark-all, the mark-all no manual and you won't have to probe the part again.
Children
No Data
© 2024 Hexagon AB and/or its subsidiaries. Privacy Policy | Cloud Services Agreement