Having to F9 every point for program to run

Hello all,

I have come across an issue I have never seen before. I picked up my tooling balls and start running the full layout. The surface points run just fine but when it gets to the trim + Hole features the program faults out.

I then have to F9 every point or right click on the feature and go into Feature -- > Reset measured values to nominal for the points to run.

Is there a setting that I have off for the program to behave this way? Once I run through the program once it runs fine.

I feel like it's something so simple causing this but can't figure out why.

Parents

Smasherofprobes over 1 year ago

Sorry I should have given more information. PC Dmis 2022.2 TTP Global S. Here is an example of the feature names "TRIM-105" and "SQS-1". Does the feature names having "-" in them really mess up the program?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Matthew D. Hoedeman over 1 year ago in reply to Smasherofprobes

Yes, they CAN mess up the program, BUT.....
With your labels, SO LONG AS those are NOT used in any calculations in the rest of the program, if they are ONLY the feature ID, then no, they should NOT cause any issues (but it is a 'bad habit' to get into). I do use the - all the time in my alignment programs, BUT they are not used in any function of Pcdmis, they are only ID labels. No problems up through 2016.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

Matthew D. Hoedeman over 1 year ago in reply to Smasherofprobes

Yes, they CAN mess up the program, BUT.....
With your labels, SO LONG AS those are NOT used in any calculations in the rest of the program, if they are ONLY the feature ID, then no, they should NOT cause any issues (but it is a 'bad habit' to get into). I do use the - all the time in my alignment programs, BUT they are not used in any function of Pcdmis, they are only ID labels. No problems up through 2016.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data