I have come across an issue I have never seen before. I picked up my tooling balls and start running the full layout. The surface points run just fine but when it gets to the trim + Hole features the program faults out.
I then have to F9 every point or right click on the feature and go into Feature -- > Reset measured values to nominal for the points to run.
Is there a setting that I have off for the program to behave this way? Once I run through the program once it runs fine.
I feel like it's something so simple causing this but can't figure out why.
WilliamL Void Detection is only turned on for trim points. I normally do not use void detection on trim points but as I stated before I did not write this program.
Does the program always fault in the same exact spot? Maybe right after an alignment before it goes to the trim? I'm not sure if it'll even help to turn Void Detection off, but have you tried that? I know it will probably be a lot of work.
Does the program always fault in the same exact spot? Maybe right after an alignment before it goes to the trim? I'm not sure if it'll even help to turn Void Detection off, but have you tried that? I know it will probably be a lot of work.