I have come across an issue I have never seen before. I picked up my tooling balls and start running the full layout. The surface points run just fine but when it gets to the trim + Hole features the program faults out.
I then have to F9 every point or right click on the feature and go into Feature -- > Reset measured values to nominal for the points to run.
Is there a setting that I have off for the program to behave this way? Once I run through the program once it runs fine.
I feel like it's something so simple causing this but can't figure out why.
Benedictj1 I can't remember exactly what the error was but sometimes It would just shoot way over to the middle of nowhere and try to measure a point or I believe it would show a travel error. Once I F9'd the point and measured it went back to running normally.
Benedictj1 I can't remember exactly what the error was but sometimes It would just shoot way over to the middle of nowhere and try to measure a point or I believe it would show a travel error. Once I F9'd the point and measured it went back to running normally.