I have come across an issue I have never seen before. I picked up my tooling balls and start running the full layout. The surface points run just fine but when it gets to the trim + Hole features the program faults out.
I then have to F9 every point or right click on the feature and go into Feature -- > Reset measured values to nominal for the points to run.
Is there a setting that I have off for the program to behave this way? Once I run through the program once it runs fine.
I feel like it's something so simple causing this but can't figure out why.
I saw this happen on our Global. Appears to have been a corruption in the program when a constructed feature math fails. Any constructions in your program? Does the part vary much?
I tried getting it to crash using the Hexagon block, nothing. I am going to try one of my models today.
I saw this happen on our Global. Appears to have been a corruption in the program when a constructed feature math fails. Any constructions in your program? Does the part vary much?
I tried getting it to crash using the Hexagon block, nothing. I am going to try one of my models today.