I've got a pretty annoying problem. So we have 3 CMM, each has same probes, same angles etc.
Recently all of the probes were remade as, few were added to first machine to match the rest.
The problem is from time to time that during calibration (partial) new angle appears, with the *.
As it is partial calibration, it stops with error. With full calibration (scan) it would get through.
But the point is new angle is being added to the list, that no one did add!
Rack changing angle is A0B0, Automatic Adjust Probe Head Wrist is off.
We did delete some unwanted angles in the past but the problem still appears, on all CMMs even after rebuilding the probes.
We are using PC-Dmis 2017 R1.
Default head and module build:
So today we had the same problem on one of our CMMs.
Angle A90B180 just showed up from nowhere as new angle, and program just stopped as it was running partial calibration.
Then why it only adds to my S10 probe? I have probe S14 that has only A0B0 and nothing was added.
And if its added automatically is there any option to turn it off?
It adds the angle to the actual probe only. If you start a program with s14 at A15B135, it will be add to s14 only.
I don't think it can be disabled, but I'm not sure if it.