(1):
what would your dimensional report to a customer look like, if there is a callout like
and you get a position of 0, because the B(M) datum shift is used ?
I think this will cause questions if i report 0 in the measurement report
one more question to that topic:
if we use this example again...
what does it mean, if there are red values in the cad-landscape report next to the datum b ?
i have not yet fully understood the information on the datum mmb.. it shows the unused datum shift potential ?! how can this be red (OOT?)
(2):
with a callout like this
PC-DMIS 2017 reports:
good measurements like >> MEAS: 0,30 MAX 0,30 MIN 0,10
OOT measurements like >> MEAS: 0,40 MAX 0,30 MIN -0,10
why is the good report the MAX value and the OOT report the MIN-MAX range, and how should this be reported to the customer ?
do you report meas, min and max, because reporting 0,40 and say its n.o.k looks confusing.
thanks
