Looping Alignments

Old Zeiss guy here... I know, I know... anyway...

We used to "loop" our alignments to a measured "break condition" before running our programs (this was to ensure the mathematical skew of the part after on alignment loop had compensated the proper amount and direction for the misalignment of the part on the fixture.)

Is there any way to do that in PC_DMIS?

Parents

AndrzejDamianSypien over 1 year ago

but iterative alignment works only with points ? points not allways are enouf, i have parts where i cannot make lignment this way
in calypso it can work with entire elements like lines planes also made of few other elemnts.

i usually used to measure the same things few times here
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

AndrzejDamianSypien over 1 year ago

but iterative alignment works only with points ? points not allways are enouf, i have parts where i cannot make lignment this way
in calypso it can work with entire elements like lines planes also made of few other elemnts.

i usually used to measure the same things few times here
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data