Parameter Sets and Autocalibration

Interesting. You selecting ALL makes it run? What version of PC-DMIS are you in? I don't know that it matters, but I use 2021.2.

Also I do it per probe build, not per part basis.

2023.2, so when I've usually set up this is how i used to do it by using mark used however if I leave it blank and then select used in routine it doesn't select any angles other than the one.

Thats what im trying to move to now

I am not 100% sure if this helps. But here is my screen.

Do you do anything else before getting to this menu?

All I do is F9 my probe, click measure, then modify the window above to be "Used in Routine". I also do DCC+DCC. I see you just do DCC. Not sure if that even matters either.

Just went downstairs to the CMM and had a look and still cant seem to get it to work.

$$ NO,
            ******************************************************
            ******************************************************
             
            THIS PART HAS BEEN PROGRAMMEND WITH AUTO CALIBRATION
             PLEASE START PROGRAM AS PER NORMAL TO START THE
                         AUTO CALIBRATION PROCCESS
            
            ******************************************************
            ******************************************************
C9         =COMMENT/YESNO,NO,FULL SCREEN=NO,AUTO-CONTINUE=NO,OVC=NO,
            Do Probes Require Calibration?
            IF_GOTO/C9.INPUT=="YES",GOTO = PROBES
            GOTO/END_PROGRAM
PROBES     =LABEL/
            COMMENT/OPER,NO,FULL SCREEN=NO,AUTO-CONTINUE=NO,OVC=NO,
            * * * * * * * * * * * * * * * * * * * * * * * * * * * 
                            PROBES FOR CALIBRATION
            * * * * * * * * * * * * * * * * * * * * * * * * * * * 
            LOADPROBE/LEITZ TREE 02 2X50
            TIP/T1A0B0, SHANKIJK=0, 0, 1, ANGLE=0
            AUTOCALIBRATE/PROBE, PARAMETER_SET=USED_IN_PROGRAM, QUALTOOL_MOVED=NO, 
                          CHECK COLLISION=NO, SHOW_SUMMARY=NO, OVERWRITE_RESULTSFILE=YES
            LOADPROBE/LEITZ TREE 01 1X50
            TIP/T1A0B0, SHANKIJK=0, 0, 1, ANGLE=0
            AUTOCALIBRATE/PROBE, PARAMETER_SET=USED_IN_PROGRAM, QUALTOOL_MOVED=NO, 
                          CHECK COLLISION=NO, SHOW_SUMMARY=NO, OVERWRITE_RESULTSFILE=YES
            LOADPROBE/LEITZ TREE 03 03X35
            TIP/T1A0B0, SHANKIJK=0, 0, 1, ANGLE=0
            AUTOCALIBRATE/PROBE, PARAMETER_SET=USED_IN_PROGRAM, QUALTOOL_MOVED=NO, 
                          CHECK COLLISION=NO, SHOW_SUMMARY=NO, OVERWRITE_RESULTSFILE=YES
END_PROGRAM=LABEL/

This is the code that is used to implement autocalibration currently into programs, and from there we would create a parameter based on the part, however I'm hoping to get this new way you found of doing it to work so it can go into every program we do.

Okay so from the measure window go to your parameter set dropdown, and select your created set, and hit measure. Does it show your tips being selected? I made a new probe build with few tip angles so I can see this in action.

Before hitting measure with parameter set selected.

After hitting measure with parameter set selected.

If you make parameter sets for each probe build that exists in your programs, you do not need to make a set based on the part, unless you mean to only qualify specific tips and angles per part depending on which is needed.