Need help for Blade inspection

I am using PC-DMIS version 4.1, mr-1. Need to inspect blade/blade twist. How can I using noted software? Note: After reading the forums can I come to the conclusion that without "Blade" software and training that it is almost impossible?

Thank you, CMM Corey

Parents

Brian Gudauskas over 15 years ago

Some helpful information for future forum readers:

Wiki entry: http://pcdmiswiki.org/index.php?title=Blade

Blade is a production inspection and analysis module for PC-DMIS that encapsulates original equipment manufacturer correlated calculations for companies such as: GE, Pratt & Whitney, Rolls Royce, Snecma, Honeywell and many others.

If there is a table of calculations on your print such as: chord length, leading edge thickness, trailing edge thickness, maximum thickness, hook angle, leading edge radius, lean, displacement, or bow, you should look into Blade.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

Brian Gudauskas over 15 years ago

Some helpful information for future forum readers:

Wiki entry: http://pcdmiswiki.org/index.php?title=Blade

Blade is a production inspection and analysis module for PC-DMIS that encapsulates original equipment manufacturer correlated calculations for companies such as: GE, Pratt & Whitney, Rolls Royce, Snecma, Honeywell and many others.

If there is a table of calculations on your print such as: chord length, leading edge thickness, trailing edge thickness, maximum thickness, hook angle, leading edge radius, lean, displacement, or bow, you should look into Blade.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data