How to move move all points of measured plane for offset datum

Hi
I have three datum targets these are three areas, each of them contain several points. Two of this planes have to be moved in Z axis so i can create datum of it.

Is it possible ? so i can make plane and offset it instead of making each individual point and offseting it ?
offseting plane by construction > offset plane is not an option i need a plane witch contains points and deviations

Parents

ArkansasBeeper 10 months ago

Consolidate each of the datum target areas into 1 best fit point point each. (if you are using a plane feature, use points instead)
Then create offset points as needed.
Then construct a plane out of your resulting 3 points that are all now on the same level.

Not sure what you mean by needing the points and deviations, your datum should be what is used to measure all the deviations from?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

ArkansasBeeper 10 months ago

Consolidate each of the datum target areas into 1 best fit point point each. (if you are using a plane feature, use points instead)
Then create offset points as needed.
Then construct a plane out of your resulting 3 points that are all now on the same level.

Not sure what you mean by needing the points and deviations, your datum should be what is used to measure all the deviations from?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data