Hi all, recently we only use clearance cube as it works perfect for our complex parts. We do not waste any time, however I did notice that collision detection is not working properly. It shows a lot of errors where actually the program will work fine. It look like the collision detection does not recognize the clearance cube. Any solution ?
Thanks for all your unnecessary comments however can someone answer my question please ?
your question was answered..if clearance cube isn't working then go to clearance plane or something else. clearance cube is cumbersome to use & most real programmers shy away from it.
you didn't even post your code...do you want us to diagnose your program issue by looking through our magical pc dmis crystal balls? tone down with the attitude lil' guy we're trying to help you here
I myself do not like clearance cube, it adds a lot of time to the program. Spend a few extra minutes in the beginning with individual avoidance moves, once you get used to it you can cut a lot of time out of your routines. Collision detection isn't always accurate, especially as forementioned if you are using a star probe.
I myself do not like clearance cube, it adds a lot of time to the program. Spend a few extra minutes in the beginning with individual avoidance moves, once you get used to it you can cut a lot of time out of your routines. Collision detection isn't always accurate, especially as forementioned if you are using a star probe.
