Auto Cleaning Probes

Question

Hello All, 
 
 So I'm currently doing a lot of improvements to my factory and one thing that id like to try implement is auto cleaning the probes, I've heard of ones being available to the likes of Mitutoyo however i am unable to find any form of solution to this anywhere else for hexagon products. 
 
 If it is possible can anyone help me out and point me in the direction please? 
 
 We do currently clean probes in the morning and when required however out night shift also run the CMMS but only at operator level, so (in theory) before and after a probe has been used as its being put away it would go to a cleaning pot of sorts and then be cleaned and then put away as so night shift don't get dodgy readings and then when we come in its due to a bit of dirt on the probe because they didn't notice it picked it up from a different part they checked. 
 
 All Help is appreciated and thanks in advance

Aaron Baldauf · Accepted Answer

I once looked into this one: 
 https://stylicleaner.com/ 
 I didn't end up buying it because the majority of our probe trees are too complex to use it. But I can imagine if you only have simple probe builds it could be very useful. 
 While they have programs for Mitutoyo machines you can use the unit with any Software, you just need to program the movements yourself.