We have use 2 probe use in same program.One is TP20 and another one is HP10.L (Laser PROBE).How to create linkage between two probes.

Question

pl see below image for understanding. 
 My question is two master sphere with different diameter and length .How to create linkage with TP20 and LLP probes ? 
 
 Pl see image for your reference.

Karuppasamy · Answer

Pl support

Karuppasamy · Answer

Pl support for answer

Karuppasamy · Answer

Can we use only 25.5 ceramic sphere for TP20 tip calibration A0B0 and other tips and Laser sensor also.Can I eliminate steel.sphere? 
 Pl explain regarding this.

Karuppasamy · Answer

Thanks Sir, 
 O ther TIP ANGLE (EXCEPT TIP A0B0) 
 Can I calibrate TP20 All tip angle with steel master sphere and HP-L-10.6 all tip angle with ceramic master sphere. It will be coorelate between TP20 and Laser probe. We can use TP20 and laser probe for same part measurement.

Karuppasamy · Answer

i think it is ceramic sphere So i follow Willam Sir as said.Sorry for understanding. 
 
 I calibrate TP20 probe and Laser above as per your guidelines, 
 
 Thanks a lot.