Probe dwells

It was the return speed in options... thanks

These setting are machine configuration specific (so can vary depending on probe type, controller type and machined frame - typically they can be different especially on larger machines) and shouldn't really be changed. 

Changing them can have an adverse effect of the accuracy of the CMM.

That doesn't mean that they were set correctly however.  It could well be the positioning or probing accuracy settings causing this dwell.

These setting are machine configuration specific (so can vary depending on probe type, controller type and machined frame - typically they can be different especially on larger machines) and shouldn't really be changed. 

Changing them can have an adverse effect of the accuracy of the CMM.

That doesn't mean that they were set correctly however.  It could well be the positioning or probing accuracy settings causing this dwell.

Got fat fingered during setup... thanks anyway