Finding New CMM Programmers

what are yalls best tips for finding new pc-dmis cmm programmers?

in the past we've found it pretty difficult to find qualified cooperative people... i'm hoping yall have some "best practices" to share with us.

we have an immediate opening for a direct hire, full time position working in a gage lab primarily doing FAIs but also creating/troubleshooting production programs in greenville, south carolina.

thoughts?

Parents

0 Duane Wade 7 months ago

I went for a job interview 3 years ago and when I got there I was asked to write a small program and then we would watch it run. This was on Calypso (which I hadn't touched in 3 years) and when I got the program done (offline) we ran the program and it was 3 minutes quicker than their current program and matched their results within microns.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 Duane Wade 7 months ago

I went for a job interview 3 years ago and when I got there I was asked to write a small program and then we would watch it run. This was on Calypso (which I hadn't touched in 3 years) and when I got the program done (offline) we ran the program and it was 3 minutes quicker than their current program and matched their results within microns.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

0 Cris_C 7 months ago in reply to Duane Wade

Nice!
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 ArkansasBeeper 7 months ago in reply to Cris_C

Sweet!
I don't care what your resume says you can do. I only care what you can actually do.

98% certain that I got a machining job once because part of the interview they gave you a knowledge test, then sat down with you and sketch and asked "how would you machine this part" the first thing I said was "what is it made out of?" I guess no one else thought to ask that question, but you can't cut it unless you know what you are cutting.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel