I cant seem to figure out how to make non symmetric tolerances on PC-DMIS, something like 110mm -0.05/-0.1 tolerance. It'll only let me do a positive/negative tolerance like 110 +0.05/-0.1. A temporary solution ive found is to just put the nominal somewhere in the middle of the tolerance but it doesnt seem like a great permanent solution. Does anyone know how to do it better?
I also don't know how to do it whit the standard settings.
So i have checked that the minus tols show negative in the setup options.
F5 --> Dimension --> Check "Minus tols show negative.
Then you can easily edit your tolerances
I also don't know how to do it whit the standard settings.
So i have checked that the minus tols show negative in the setup options.
F5 --> Dimension --> Check "Minus tols show negative.
Then you can easily edit your tolerances
