recall/align missing ID message

Hello all, I recently adjusted a program to use a new alignment and deleted the old ones. The program runs fine but now I get a message that says recall/align missing ID.

Who know what this message means and how to correct it?

Thanks.

0 WilliamL 9 months ago
I've seen this happen to me recently, and no idea what causes it. I fiddled with my alignments and saw this.

RECALL/ALIGNMENT,INTERNAL,A2 RECALL/ALIGNMENT,INTERNAL,A2:INTERNAL

For some reason my recall alignment was adding another internal at the end, when it usually looks like the first example. Try looking for that. I can't remember if I fixed it by removing the extra "internal" or not.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Neil Challinor 9 months ago in reply to WilliamL

The message means that the alignment name is missing from the recall command - so it's essentially empty and doesn't know what to recall.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 WilliamL 9 months ago in reply to Neil Challinor

I have gotten the same error message as the poster, even when my alignment name is not missing. It also added an extra "internal" to the end of an alignment.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Somethingidc 9 months ago

Thanks for the replies so far. I cleared the error by changing the recall in the alignment utilities to "use active alignment" for the recall. I will try removing the extra "internal" also.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel