I am in the process of customizing the CAD- only landscape style report for a measurement routine as this format suits our needs the best. Within each page, I can zoom in/out on the CAD model that allow me to display a specific area of the part where I would like specific features to be displayed. Let's say I have 200 holes, slots, surface points, etc. that are measured, but I only want to report certain feature groupings that are close to each other on the scanned part.
For example, right now page 1 displays features 1-15 which are in the top left of the scanned part, page 2 displays features 16-30 but I need page 2 to only display features 16-20 because those 5 features are in close proximity with each other at the top right of the scanned part. Page 3 should only display features 21-30 for the same reason.
Is there something I can write within the program or do within the report that would allow me to section off which exact features I want to report on a specific page?
I want to add that I have all features within the program in the order I would like them to be reported, I just don't know how to section them off.
I was told the formfeed/ command would allow me to section the features off by page as well, however it did not work.
I have also tried to increase the label count per page to 20 and then duplicate the page to section off the features I want to group together but this hasn't worked properly because certain features will still fail to be reporting on that specific page.
I would greatly appreciate any feedback!
Thank you for your support!
