Like title!
In order to trigger a new report page with a CADObject on it, you must first have a RECALL VIEW command in the program.
After that, you MUST have either a DIMINFO or COLORMAP command, otherwise there will be no new page.
I would like to have SNAPSHOT added to that list (together with DIMINFO and COLORMAP) that triggers a new page.
If you use snapshot alone, no new page will be generated and you will not have your picture on the report.
There are a lot of hoops to go through just to have a new page with a CADObject on it and I have noticed that it isn't
working that good either. Sometimes when adding a DIMINFO, it shows up on my first view in the report, where I have
my colormap... and you can't remove the DIMINFO from that view as I can't even select it in the report editor.
Additionally, the pointclouds are not visible when generating the PDF's, it shows up nice in the report view, but not
in the actual PDF. I know we have gone through this earlier Neil Challinor but I can't remember what to do in
order for the pointclouds to actually display?
