PCMDIS/NC Expereinces?

Hi all,

Have been given the task of getting PCDMIS NC going on one of our machining centres for an demonstration here in Australia.

Would love to hear from anyone with prior experience using this software, and more importantly the NC server application.

Have been trying in vain to set up comms between the PC and M/C, followed the instructions and succesfully verified comms using HyperTerminal, but upon opening NC Server and defining a machine and specifying the serial type interface, I get the error message "Cannot Open Serial Port".

As far as I can tell, I have followed instructions to the letter, but to no avail.

Would appreciate anyones comments on the possible solution to this problem.

Cheers, and have a lovely weekend.

Danny

Parents

kiddo over 18 years ago

thanks for the reply jan:

by saying that u mean that u inspect the part on the machine once it is done cutting and is that result good enough for quality purpose I mean by doing that do you eliminate the first piece inspection done by quality... or else is that result good enough to provide to the customer ... just asking....

thanks
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

kiddo over 18 years ago

thanks for the reply jan:

by saying that u mean that u inspect the part on the machine once it is done cutting and is that result good enough for quality purpose I mean by doing that do you eliminate the first piece inspection done by quality... or else is that result good enough to provide to the customer ... just asking....

thanks
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data