I am reverse-engineering a large structure and attempting to use a manual scan with fixed delta (i want to take a point every inch) and uncompensated points. There is no CAD data in this program.
The problem is that the points being created are being compensated relative to the orientation of the probe. the comp distance is not equal to the probe radius (15mm probe). Probe comp on or off does not make a difference.
If I use a variable delta scan with probe comp off this does not happen but I will wind up with too much data.
I've searched the help(less) files for an answer but cannot find it. Does anyone know what I am missing?
This error has cost me considerably. Tha project is off-site and very difficult to measure to begin with. I need to find a solution by tomorrow.
Thanks in advance,
Joe
