Where do I start? I have the probes. I am currently running version 2009. Is it possible to you the non contact probes with this? How do you calibrate them? Any info would be much appreciated!
I have 3 probes. 25mm 75mm and 100mm. I do not have any (armdata?) for the probes. Cimcore arm utilities recognizes the 100mm non contace probe as a different probe. I was hoping to measure hydrualic tubes, and bends in plate steel. I am not sure if I have the correct software as stated above. I have a old copy of Supravison but no licence. Again any information would be much appreciated.
I have 3 probes. 25mm 75mm and 100mm. I do not have any (armdata?) for the probes. Cimcore arm utilities recognizes the 100mm non contace probe as a different probe. I was hoping to measure hydrualic tubes, and bends in plate steel. I am not sure if I have the correct software as stated above. I have a old copy of Supravison but no licence. Again any information would be much appreciated.
