I am using a 6.35mm (.250") Probe to calibrate a simple 12" block
I keep getting a 12.500 reading.
What is the Edit Probe Data suppose to be in
X, Y, Z Center
Diameter & Thickness?
or does anyone know what could be the problem. I calibrated to the 1" ball w/in .001.
Are you certain that your your 12" block isn't 12.5"? Check it with calipers or even a tape measure. It just seems to me that the numbers are too even.
Are you certain that your your 12" block isn't 12.5"? Check it with calipers or even a tape measure. It just seems to me that the numbers are too even.