I seem to have a problem getting them match up, i bring in my Cad Modal and take the Aligh hits on the Modal and the do the same to the part. what am i missing here?
yes i ahve had training but this something that is not done very often. i do as i am told about the points and i do get to point where my arm follows the and the cad , but i guess the main question would is if it is possible to see a true cad to part comparison? i take hits on the and then go to a dis. of 2 lines can it give a differance from the cad ?
yes i ahve had training but this something that is not done very often. i do as i am told about the points and i do get to point where my arm follows the and the cad , but i guess the main question would is if it is possible to see a true cad to part comparison? i take hits on the and then go to a dis. of 2 lines can it give a differance from the cad ?