We have a part that we are trying to check that is a reduced dimension drawing. So therefor we are trying to check some profiles to the model. My question is how to be able to scan the part and go back to the model. We don't have a scanning head and we are using 4.3 cad and I am up for suggestions
I did figure some out the only thing I haven't been able to figure out is on a manual scan how to change the amount of points it takes and this is my first time using a romer
(F5) Part/Machine Tab Adjust Minimum time and or distance delta to regulate how fast points are taken when holding down button 2. Otherwise if an actual scan from the insert menu is used some of them have a field for controlling how points are collected.
Jeffrey P. Master
PC-DMIS Support 1-800-343-7900
Romer Tech Support 1-800-218-7125 Software {techsupport@romer.com} Hardware {support@romer.com}
If you choose not to decide you still have made a choice. --Rush