New romer arm

Hi my learned colleagues.
I haven't posted on the forum for quite a while (at the point where I knew everything i needed to know i guess!)
Anyway, i have years of experience with PCDMIS on our cmm, but we have just bought a romer arm with pcmis portable to run it. Anybody give us a heads up for likely issues that may arise?
Any feedback at all would be greatly appreciated!

Parents

juangsheng over 13 years ago

While using with PCDMIS Portable, try not to use the "Guess" features.
I would strongly suggest select the features that you wanted to measure prior to measuring the part.
For inner circles, remember to End Feature inside the hole, for outer circle, End Feature outside the shaft.
For any first hit on any features, try to have the probe normal to the surface of measurement.
Some tips for PCDMIS Portable, hope it helps.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

juangsheng over 13 years ago

While using with PCDMIS Portable, try not to use the "Guess" features.
I would strongly suggest select the features that you wanted to measure prior to measuring the part.
For inner circles, remember to End Feature inside the hole, for outer circle, End Feature outside the shaft.
For any first hit on any features, try to have the probe normal to the surface of measurement.
Some tips for PCDMIS Portable, hope it helps.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data